طريقة فك موبيل نوكيا n 70

**TiTo lamor** · 11-13-2008, 11:46 PM

[hide]

بسم الله الرحمن الرحيم

طبعا الكلام بالنكليزيه

لكن الصور بتلكم كل اللغات

..

Step 1. Protect the display with a film to prevent damage.

Step 2. Remove the battery cover.

Step

3. Place a plastic shim between the fascia and chassis and release the

four clips indicated below. Turn the handset over and lift the fascia

away.

Step 4. Remove key mat.

Step 5. Protect the screen with a film or similar.

Step 6. Also protect the inside if the screen ********

Step 7. Remove the MMC card door.

Step 8. Insert your shim between the aerial cover and the chassis and release all clips to remove the cover.

Step 9. Use tweezers to remove the power button.

Step 10. Protect the camera bezel with a film.

Step 11. Remove the camera gasket.

Step

12. I suggest that you only remove the camera unit if you have access

to the correct tool for the job - otherwise leave it in place.

Step 13. Remove the six Torx T6 screws in the order shown below and store them safely.

Step

14. Lift the user interface assembly from the chassis taking care not

to induce strain on the foil connector that will still be attached

underneath.

Step 15. Carefully release the flex connector using a flat bladed screwdriver.

Step 16. Release each clip of the LCD frame and remove the screen.

Step 17. Remove the ear piece from the frame.

Step 18. If you need to remove the ear piece gasket be aware that it is glued in place and should be replaced for reassembly.

Step 19. Unclip the shield assembly.

Step 20. Now push down and remove the shield.

Step 21. Pull the frame slightly to release the user interface board.

Step 22. Now the user interface board can be removed.

Step 23. Remove the main circuit board.

Step 24. Remove the vibra motor.

Step 25. Remove the microphone.

Step 26. Remove the power jack using an unplugged charger.